Browse
 
Tools
Rss Categories

M3027 M3035 P3005 Noise Reduction Kit

Author: Fuser Printer Parts Reference Number: AA-00139 Views: 5489 Created: 06-17-2010 03:56 pm Last Updated: 09-18-2013 04:22 pm 0 Rating/ Voters

P3005 Series Noise Reduction Kit

 

Installation Instructions:

 

1.     Unfasten the two screws securing the rear panel/face up tray and

        remove it. Also remove the AC input cover.

2.     Remove the fuser output paper guide and the fuser.

3.     Remove the lower roller gear and intermediary gear from the fuser.    Dispose of the used gears and install the new replacement gears in

        their place.

4.     Looking into the rear of the printer, locate the gear cluster on the

        upper left side.

5.     Release the clip securing the upper-outside gear and slide it off of its

        shaft. Also remove the gear found directly below it. Dispose of the

        used gears and install the new replacement gears in their place.

6.     Note its orientation and carefully remove the clip securing the upper

        inside gear. Slide the upper inside gear off of its shaft. Also remove

        the gear found directly below it. Dispose of the used gears and install

        the new replacement gears in their place.

7.     Reinstall the clip that secures the upper inside gear.

8.     Reinstall the fuser and the fuser output paper guide.

9.     Reinstall the rear panel/face up tray and the AC input cover.


For parts pricing and availability contact

Sales@metrofuser.com or

http://www.metrofuser.com/

printer parts, HP printer parts, fuser error, hp fuser,lexmak fuser